🇰🇷 한글 설명
Linux 커널의 memcg(Memory Control Group)에서 obj_cgroup_charge_pages() 함수가 루트 memcg에 대한 과금을 적절히 차단하지 못하는 취약점입니다. 이로 인해 zswap 등을 통해 메모리가 해제될 때 루트 memcg의 페이지 카운터가 비대칭적으로 증가하여 메모리 누수가 발생할 수 있습니다.
💡 쉬운 설명
시스템의 메모리 관리 기능 중 하나에서 계산 오류가 발생하여, 사용하지 않는 메모리 수치가 계속 올라가는 현상이 발생합니다. 이는 시스템의 메모리 사용량을 정확하게 파악하지 못하게 만들고 메모리 누수를 유발할 수 있습니다.
🇺🇸 원문 (English)
In the Linux kernel, the following vulnerability has been resolved:
memcg: avoid charging the root memcg from obj_cgroup_charge_pages()
obj_cgroup_charge_pages() resolves the objcg to its memcg and calls
try_charge_memcg(), which does not short circuit the root memcg. That
memcg can be the root memcg: obj_cgroup_is_root() reflects the memcg the
objcg was created for and is never updated, while memcg_reparent_objcgs()
does redirect objcg->memcg to the parent on rmdir. An objcg of a dying
child of root therefore passes every obj_cgroup_is_root() filter but
resolves to the root memcg.
Folios keep the objcg they were charged with, so this is easy to reach
through zswap: allocate anon memory in a cgroup, move the task out, remove
the cgroup, then write to the root cgroup's memory.reclaim. The reclaimed
folios are charged through the reparented objcg and end up in
refill_stock() with the root memcg:
WARNING: mm/memcontrol.c:2198 at refill_stock+0x644/0x940
refill_stock+0x644/0x940
try_charge_memcg+0x12d6/0x1570
__obj_cgroup_charge+0x35/0xf0
obj_cgroup_charge+0x1de/0x210
obj_cgroup_charge_zswap+0x83/0x270
zswap_store+0x1620/0x2000
swap_writeout+0x94c/0x14c0
shrink_folio_list+0x3388/0x52b0
[...]
try_to_free_mem_cgroup_pages+0x30d/0x830
user_proactive_reclaim+0x504/0x840
memory_reclaim+0x1f/0x30
Beyond the warning, the charge is asymmetric: obj_cgroup_uncharge_pages()
skips refill_stock() for the root memcg, so the root's page counter grows
and is never uncharged. It is not user visible, since memory.current is
not exposed on the root, but it is a leak.
Use try_charge(), which returns early for the root memcg, restoring the
symmetry with obj_cgroup_uncharge_pages().
The above sequence was scripted into a standalone reproducer (zswap on,
swap on a virtio disk, 512MB of anon memory faulted in inside a child of
the root cgroup, the task then migrated to the root cgroup, the child
removed, followed by "echo 600M swappiness=max > memory.reclaim" on the
root) and run in a CONFIG_DEBUG_VM=y VM. It reproduces the splat on the
first zswap store of a reparented folio, with the same call chain as the
report. With this patch applied the splat is gone while the zswap store
count over the run is unchanged, so the same path is still exercised.
cgroup selftests test_zswap, test_kmem and test_memcontrol show no new
failures.
📍 영향받는 시스템
Linux Kernel (zswap 및 memcg 기능을 사용하는 시스템)
⚔️ 공격 벡터
특정 시나리오(cgroup 생성, 작업 이동, cgroup 삭제 후 zswap 동작)를 유도하여 루트 memcg의 메모리 카운터를 누적시킴
🛡️ 대응 방법
Linux 커널을 최신 보안 패치가 적용된 버전으로 업데이트하여 obj_cgroup_charge_pages()가 try_charge()를 사용하도록 수정해야 함
🔧 검증 코드
출력된 커널 버전이 해당 취약점이 해결된 패치 버전 이후인지 확인하십시오.